Roll over image to zoom in
- Class-D amplifier providing 50 watts/channel (RMS) into 8 ohm loads or 65 watts/channel into 4-ohm loads
- Bridgeable output provides 120 watts into a single 8-ohm load
- 4-pole detachable speaker screw connector (Phoenix connector) with support for up to 12 AWG speaker wire
- 12-volt trigger input for power-on/off
- 12-volt trigger output for controlling other devices
- Buffered loop output of original signal for connecting additional amplifiers
- Rear panel volume gain adjustment
- Built-in thermal and short circuit protection circuits
- Includes rack-mount ears for mounting a single unit, or two units side-by-side
- Includes trigger cable to connect to CT-12X8MA
- Audio Inputs: Stereo Analog RCA
- Audio Outputs: Buffered stereo analog RCA loop output
- Output Power: 50 watts per channel into 8 ohms , or 65 watts per channel into 4 ohms, or 120 watts into a single 8 ohm load
- Minimum Output Impedance: 4 ohms in stereo mode, 8 ohms in mono bridged mode
- Total Harmonic Distortion plus Noise (THD+N): <0.1% for all modes
- Trigger Input: 12 VDC, 10 kΩ
- Trigger Output: 12VCD, 100mA
- Input Power: 100 – 240 VAC, 50/60Hz, 2.5A
- Standby Power Consumption: ≤ 0.5 watts
- Dimensions: 8.5” x 10.5” x 1.8” (216 x 267 x 45 mm)
